Thatch Tiki Bar

Product	Qty	Price
Thatch Tiki Bar (Hexagonal Shaped)	1 - bar	$4500.00 ea.
Call toll free to place your order (877) 243-5309

We are volume importers and offer competitive rates and bulk discounts. Call Toll free: (877) 243-5309

For more info. on Thatch Tiki Bar, please fill out our information request form.

 

Thatch Tiki Bar Installation Instructions:

1.   The Bar consists of the following parts. Please check that all parts are present when unpacking.

• 6    bottom sections marked 1 through to 6

• 6    top sections marked 1 through to 6

• 6    stem glass hangers marked 1 through 6

• 6    bar top sections marked 1 through 6

• 4    posts for roof

• 3    40” posts for bottom sections

• 3    18” posts for top sections

• 1    fan with electrical cord

• 1    12” rope light

• 4    bottle holders

• 1    serving board

• 1    serving board support

• 1    packet of hardware

• 1    spacer for top racks

• 4    roof quadrants

• 1    thatch top cone

• 30  thatch panels

2. Lay out the 6 bottom panels marked 1 through 6 on a flat surface to form an octagon with 2 open sides.

 

3. Connect sections with 3 x 40” posts as marked to form 3 sections of 2 pieces. (Hardware = 4” wood screws)

 

4. Connect the 3 sections with the 2 front posts and 2 rear posts as marked. (Hardware = 4” wood screws)

 

5. Connect the top section in 3 pairs of two as numbered with 3 x 18” posts. (Hardware = 4” wood screws)

 

6. Using the spacer install the top sections between the main posts. (Hardware = 4” wood screws)

 

7. Install the stem glass hangers as marked under top sections. (Hardware = 1 ½” wood screws)

 

8. Install serving board support between bottom sections 3 and 4(Hardware = 2” wood screws)

 

9. Install serving board. (Hardware = 2” wood screws)

 

10. Install bar tops ensuring a tight fit between each section.

 

11. Secure with 1 ½” screws to support plates.

 

12. Assemble roof quadrants with bolts and nuts supplied. (Hand tighten at first and then tighten with wrench when all quadrants are fitted together.

 

13. Lift roof section on upright posts, fitting joints in the post cutouts. (3 people required)

 

14. You have been supplied with the following components: 1 thatch cone, 30 regular thatch panels and 2 heavy duty panels.

Thatch panels are clipped to the round bar hoops, (not to the outermost flat bar hoop).

 

thatch tiki bar - Attaching the thatch (2 people):

1. Starting at the outer lower level round hoop, not including the flat-bar hoop, clip on a regular weight thatch panel. The reed will overhand the frame approximately 10 inches.

 

2. Put the next panel in place beside the first panel, etc. all the way around.

 

3. Butt adjacent panels snugly against each other

 

4. You will need to trim only one panel per hoop using a utility knife.

 

5. If the flat rib section of the steel frame interferes with the clips, shift the panel a few inches either way. This will ensure that all the clips clasp over the round bar.

 

6. Now do the same for the next hoop and continue until all hoops are full of thatch.

 

7. The thatched top cone is placed centrally on the outside and is kept in place by its own weight. From the underside a broom handle can assist to drop and situate the thatch cone centrally on the umbrella.

 

thatch tiki bar - Final Grooming

1. While the ladder is still up, go around the entire roof and remove any loose pieces of thatch reed.

 

2. Then go to the underside of the umbrella and carefully pat out the underside of the thatch, lifting the reeds briefly off the steel framework to allow the reeds to rest and settle evenly on the outside of the frame. Continue this on each tier of the roof. This procedure ensures that the thatch is evenly distributed and closes any gaps.

 

3. Assemble and hang the fan from the roof with hook bolts supplied.

 

4. Feed electrical cord through under the thatch.

 

5. Secure to left back upright with cable clips.

 

6. Install rope light under counter tops on inside of bar.

 

7. Hang bottle holders on inside supports.

Enjoy your Thatch Tiki Bar!